光圈
42 mm / 1,66", without optics
光束角度
80° Half Peak Angle, without optics
重量
Fixture only: 11,7 kg / 25.8 lbs
Manual Version: 14,2 kg / 31.3 lbs
Pole Op Version: 14,9 kg / 32.9 lbs
操控
Aluminum yoke with quick release, high strength tilt lock, pole operation option (pan and tilt)
安装
28 mm Spigot (Junior Pin)
俯仰角度
+/-90° in dry location, +75° / -90° in wet location with rain cover
电压输入范围
100 - 240 V~, 50 - 60 Hz
功耗
400 W Nominal, 500 W Maximum
主线缆连接
powerCON TRUE1 TOP
(Bare Ends / Schuko / Edison, Japanese, Chinese cables available)
电池接口
3-Pin XLR Connector (Pin 1: negative, Pin 2: positive)
白光
calibrated 2,000 K to 20,000 K continuously variable correlated color temperature
色彩模式
CCT, HSI, individual color, gel selection, x/y coordinates, source matching, lighting effects, and color sensor mode
色温误差
3,200 to 5,600 K: +/- 100 K (nominal), +/- 1/8 Green-Magenta (nominal)
高色彩再现
3.200 to 5.600 K:
CRI Average > 98
TLCI Average > 95
TM-30 Average > 94
绿色-品红校正
Continuously adjustable between Full Minusgreen to Full Plusgreen
调光
Smooth, 100 – 0%, continuously, linear / exponential / logarithmic / „S“ curve
连接性
Removable Control Panel via PoE, 5-pin XLR in and through, EtherCON in and through, 2 x USB-A, USB-C, SD Card, Camera Sync Input
控制选项
Wireless control via LumenRadio CRMX* (DMX & RDM), Full E1.20 RDM standard implementation with custom & standard RDM commands
* Brand: LumenRadio AB, Equipment: CRMX TiMo, Model: 200-1502, Product: Orbiter 2.4G Wireless Control Module, Frequency Range: 2402 - 2480 MHz, Frequency of Operation: 2402 - 2480 MHz, Power Output: 17.51 dBm, Number of Channels: 79, Channel Spacing: 1 MHz, Modulation Type: GFSK
工作环境温度
-20 to +45º C (-4 to +113º F)
IP 等级
IP 20 without Rain Cover, IP24 with Rain Cover L2.0037805
LED预计使用寿命 (光度维持70%或以上)
50,000 hours
${certifications.&.declarations.of.conformity}
CB, CE, UKCA, ENEC, cNRTLus, ICES, FCC, PSE, MIC, KC, SRRC, RCM, IFT, TRA, ETA, ANATEL, ENACOM, NTC
FCC 声明
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Canada: CAN ICES-3 (B)/NMB-3(B)
All specifications are preliminary typical values. Subject to change without notice.